It’s Back!

Winter has returned to New Hampshire.

Back yard

We got about a half inch of snow today. When I got up there was ice all over the windshield of my car. This surprised me, but I guess it should not have.

Front Yard

Some people are probably pretty upset about winter’s last gasp, but I find it a welcome return. Maybe it will be enough to tide me over until next winter (or if I’m lucky, autumn).

Penny gets ready to catch a stick

Penny didn’t seem to care. All else becomes unimportant when there are sticks to be caught.

Spring will be back again, and soon I’m sure. We had chipmunks in the yard last week. This one was at the foot of the deck stairs.

Chipmunk

I opened the sliding glass door and he turned around, but he didn’t run off. Luckily, Penny didn’t see him as I took several shots.

Another thing I did last week was visit a virtual geocache in Franklin called “Abnaki Mortar” (sic – should be “Abenaki”) From the name, I couldn’t figure out what it was, but once I got there it was plainly obvious, and I felt silly for not knowing what to expect.

Abenaki Mortar

This is a mortar where the Abenaki Indians ground corn. European settlers used it too. I imagine they would have scooped the water out and tried to dry it a bit first. I was pretty pleased when I got here and saw what it was. I really like Native American history, especially here on the East Coast where almost none was recorded before they were driven out.

Meanwhile, I have been making slow but steady progress on the canoe. In spite of today’s snowstorm, we had a spot of nice weather last week. It was warm enough to consider epoxy work, so I considered it. And did it. I fit the instem into “Miss Nancy.”

New instem

That’s a tough proposition, as the stem is kind of the foundation of the boat. The brief period during which it was stemless, it was also exceedingly fragile. Once I got this new stem in place, it regained its strength plus some extra strength for good measure. Once the epoxy set on the instem, I attacked the outstem too:

Outstem attached

Instead of clamping the outstem in place, I screwed it into the instem with steel screws. Those came out once the glue set, and will be replaced with brass screws. I generally don’t drive brass screws into wood until I’ve used a steel screw to cut the threads in the wood. Otherwise, the brass screws will twist in two, or strip out. As it was, the steel screws themselves all snapped in half when I went to remove them. I haven’t decided how to deal with that yet. Now that the epoxy is set, the screws are more decorative than anything else. I think if I tried to remove the steel screw nubbins, all I would do is mangle the ash. I might just use some shortened brass screws to plug the holes and make it look good.

Since this was done, I also shaped the outstem so that it flows into the hull with sweeping curves. It looks pretty good now. I also mixed up some epoxy and wood flour and slathered it into the cracks between the planks. I still need to hit it with another layer of that mixture and sand it down, but once that’s done, it’ll be ready to take a new layer of glass. Then the strength will increase by another order of magnitude. Once that’s done, I can smooth the inside of the hull, slather on more epoxy/wood flour, and sand that, and then it will be ready for glass as well.

This is going to be a nice boat.